MacDon M200 Manual del operador descargar pdf (Pagina 92)

HEADER OPERATION - D SERIES

Form 169017 / 169087 / 169095 90 Revision C

3. Push down on rod end of link cylinder (K) until

hook engages pin on header and is locked.

4. Check that center-link is locked onto header

by pulling upward on rod end of cylinder.

HYDRAULIC LINK WITH OPTIONAL SELF-

ALIGNMENT KIT

1. Adjust the position of the center-link cylinder

with the REEL UP and REEL DOWN

switches, and HEADER TILT switches on the

GSL to position the hook above the header

attachment pin.

2. Lower the center-link onto the header with

REEL DOWN switch until it locks into position

(handle is down).

g. Raise the header fully with the HEADER UP

switch on the GSL. Stop engine and remove key.

DANGER

To avoid bodily injury from fall of raised

header, always engage header lift cylinder

stops when working on or around raised

header.

h. Engage lift cylinder stops on both lift cylinders.

Refer to Section 6.4.1 Header Lift Cylinder Stops.

i. Install pin (F) through header leg, (engaging U-

bracket in lift linkage) on both sides and secure

with hairpin.

j. Raise header stand (L) to storage position by

pulling pin (M), and lifting stand into uppermost

position. Release pin (M).

(continued next page)

HEADER TILT UP

HEADER

TILT DOWN

REEL UP

REEL DOWN

1 2 ... 87 88 89 90 91 92 93 94 95 96 97 ... 233 234

Sin comentarios

MacDon M200 Manual del operador Pagina 92