MacDon M200 Manual del operador descargar pdf (Pagina 193)

MAINTENANCE AND SERVICING

Form 169017 / 169087 / 169095 191 Revision C

7.11.9 GAUGE LIGHT

a. Shutdown engine, and remove the key. Turn off

the lights.

b. Remove the appropriate gauge access hole decal

(A) behind the Operator’s console.

c. Remove nut (B) securing mounting bracket (C) to

gauge inside the console.

d. Pull gauge out from console. It is not necessary to

disconnect the wiring harness to back of gauge.

e. Twist bulb holder (D) counter clockwise until

loose, and pull bulb holder from back of gauge.

f. Insert new bulb into gauge, and turn clockwise

until it locks.

g. Push gauge into console.

h. Locate bracket (C) onto back of gauge, and

secure with nut (B). Tighten nut to 75 - 96 in

·oz

(530 - 678 mN·m).

i. Replace gauge access-hole decal (A).

7.11.10 DOME LIGHT

a. Shutdown engine.

b. Remove two screws (A) from plastic lens, and

remove lens.

c. Replace bulb.

d. Reinstall plastic lens with screws (A).

7.11.11 AMBIENT LIGHT

a. Shutdown engine.

b. Push against tabs (B) with a screwdriver, and pull

ambient light fixture out of cab roof.

c. Remove connectors (C).

d. Connect wires to new light fixture.

e. Push into place in cab roof until tabs hold fixture in

place.

7.11.12 TURN SIGNAL INDICATORS

If the turn signal indicators on the CDM do not

function, contact your Windrower Dealer.

1 2 ... 188 189 190 191 192 193 194 195 196 197 198 ... 233 234

Sin comentarios

MacDon M200 Manual del operador Pagina 193